Alamo Exten-A-Kut II - Manual (Page 134)

MAINTENANCE
EK II 03/09 Maintenance Section 4-2
©2009 Alamo Group Inc.
MAINTENANCE
GENERAL
Before operating your DB150, make sure it is properly lubricated and thoroughly inspected. Only a
minimum of time and effort is required to regularly lubricated and maintain this machine to provide long life
and trouble free operation.
LUBRICATION INFORMATION
Do not let excess grease collect on or around parts, particularly when operating in sandy areas. The
accompanying illustration shows lubrication points. The chart gives the frequency of lubrication in hours,
based on normal operating conditions. Severe or unusual conditions may require more frequent
lubrication.
LUBRICATION
The DB150 must be serviced daily to achieve the best operation and longest life. Good quality grease from
a hand grease gun in all grease fittings should be sufficient.
NOTE: Lubricate flail roller bearing until lubricant can
be seen coming out between roller and bering
housing.
ITEM DESCRIPTION FREQUENCY
1. Linkage Attachment 8 hours
2. Head Attachment Pin 8 hours
3. Boom Linkage Pin 8 hours
4. Tilt Cylinder Pivot 8 hours
5. Spindle Assembly 8 hours
6. Boom Sleeve 8 hours
NOTE: Check oil level and as needed.