Asus ME-99 - Manual (Page 39)

ASUS ME-99 User’s Manual 39
3. HARDWARE SETUP
Connectors
3. H/W SETUP
26) System Management Interrupt Switch Lead (2-pin SMI)
This allows the user to manually place the system into a suspend mode or “Green”
mode, where system activity is decreased to save electricity and expand the life
of certain components when the system is not in use. This 2-pin connector con-
nects to the case-mounted suspend switch. If you do not have a switch for the
connector, you may use the “Turbo Switch.” SMI is activated when it detects a
short to open moment and therefore leaving it shorted will not cause any prob-
lems. This may require one or two presses depending on the position of the
switch. Wake-up can be controlled by settings in the BIOS but the keyboard will
always allow wake-up (the SMI lead cannot wake up the system).
27) System Message LED Lead (2-pin LED)
This indicates whether a message has been received from a fax/modem. The
LED will remain lit when there is no signal and blink when there is data transfer
or waiting in the inbox. This function requires ACPI OS and driver support.
28) ATX Power Supply Connector (20-pin block ATXPWR)
This connector connects to an ATX power supply. The plug from the power sup-
ply will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.
IMPORTANT: Make sure that your ATX power supply can supply at least 10mA
on the +5-volt standby lead (+5VSB). You may experience difficulty in power-
ing ON your system if your power supply cannot support the load. For Wake-
On-LAN support, your ATX power supply must supply at least 720mA +5VSB.
ME-99 ATX Power Connector
+3.3 V
olts
-12.0 V
olts
Ground P
ower Supply On
Ground Ground Ground -5.0 V
olts
+5.0 V
olts
+5.0 V
olts
P
ower Good +12.0 V
olts
+3.3 V
olts
+3.3 V
olts
Ground
+5.0 V
olts
Ground
+5.0 V
olts
Ground
+5V Standby
01
01
01
®
ME-99