Hardware setup, Asus me-99 user’s manual 33 – Asus ME-99 User Manual

Page 33

ASUS ME-99 User’s Manual

3. HARDWARE SETUP

Connectors

3. H/W SETUP

11) Wake-On-LAN Connector (3-pin WOL_CON)

This connector connects to a LAN card with a Wake-On-LAN output, such as
the ASUS PCI-L101 Ethernet card (see 7.1 ASUS PCI-L101 Fast Ethernet Card).
The connector powers up the system when a wakeup packet or signal is received
through the LAN card.

IMPORTANT:

This feature requires that Wake On LAN is set to Enabled (see

4.5.1 Power Up Control) and that your system has an ATX power supply with at
least 720mA +5V standby power.

ME-99 Wake-On-LAN Connector

IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power

+5 Volt Standby
PME

Ground

WOL_CON

ME-99

12) Wake-On-Ring Connector (2-pin WOR)

This connector connects to internal modem cards with a Wake-On-Ring output.
The connector powers up the system when a ringup packet or signal is received
through the internal modem card. NOTE: For external modems, Wake-On-Ring
is detected through the COM port.

IMPORTANT:

This feature requires that PWR Up On Modem Act is set to

Enabled (see 4.5.1 Power Up Control).

ME-99 Wake-On-Ring Connector

WOR

PIXRI#

Ground

ME-99