American Standard COUNTERTOP SINK 293 User Manual

Page 2

Shut-Off
Valves

7 3 0 5 2 4 - 1 0 0 R e v . B

- 2 -

Mount the faucet and drain assembly (not included) on the
lavatory following faucet manufacturer's instructions. Be
certain to apply a bead of sealing putty on the underside of
the drain (Part "A") in order to ensure a watertight seal
between the lavatory and drain. Remove excess putty after
installing drain on lavatory.

Before applying the sealant, place the lavatory
temporarily into the cut-out. Check for alignment and
clearance. Then mark the lavatory and countertop in
several places as a guide for the installation location.

After checking fit and
alignment, turn lavatory upside
down and apply a generous
portion of sealant around the
underside of the rim near the
edge. Carefully lower lavatory
in place, align with marks made
earlier, and press down firmly.
Allow sealant to set before
connecting supplies and drain.

Connect supply line to faucet
(finger tight) and carefully bend
tubes to engage with the
supply shut-off valves. Tighten
connections at faucet and
shut-off valves for secure seal.

Connect trap to drain assembly
hand tight to check alignment. It
may be necessary to cut off part
of the tailpiece (area "B") or part
of the horizontal leg of the trap
(area "C"). Secure joints for
watertight assembly.

In the United States:

American Standard Brands

P.O. Box 6820

Piscataway, New Jersey 08855

Attention: Director of Consumer Affairs

For residents of the United States, warranty

information may also be obtained by calling the

following toll free number: (800) 442-1902

www.americanstandard-us.com

In Canada:

AS Canada ULC

2480 Stanfield Rd.

Mississauga, Ontario

Canada L4Y 1S2

Toll Free: (800) 387-0369

www.americanstandard.ca

In Mexico:

Customer Service Manager

AS Maquilia Mexico, S.A. de C.V.

Via Morelos #330

Col. Santa Clara

Ecatepec 55540 Edo. Mexico