APC 3000VA - Manual (Page 8)

6
3. Locate the battery module handle at the top of the
battery face plate .
4. Be careful during this step—the battery module is
heavy.
Pull the battery module handle toward you to
slide the battery module out of the UPS.
DO NOT pull on the battery cables or the white
cord.
M OUNTING THE UPS IN THE R ACK
Due to its weight, two people are required to install the UPS in the rack.
1. Supporting the UPS on both sides, carefully align
the unit with the rails. Use the handles Πon the
side of the UPS to support the unit.
2. Each side of the UPS has a cleat  that must
slide into the groove on the rails. Insert each cleat
into its groove and slide the UPS into position.
3. Use the four ornamental screws supplied with the
UPS to attach the mounting brackets to the rack
post. Insert the screws into the top and bottom
holes in the U-space.
R EINSTALLING THE B ATTERY M ODULE
1. Supporting the battery module on the bottom,
align it with the opening and slide the battery
module into the compartment.
2. Replace the two screws to secure the battery
module face plate.

Œ
Œ
