AT&T E5828B - Manual (Page 42)

39
Answering system operation
Day & time announcements
To set day and time
Before playing each message, the answering sys-
tem announces the day & time the message was
received.
Before using the answering system, follow the
steps on the left to set the day and time so mes-
sages are dated correctly. If the clock is not set
before playing messages, the system will prompt
"Time and date not set" each time.
The system uses voice prompts to guide you.
Each time you press
SKIP or REPEAT , the
day, hour, minute or year increases or decreases
by one. When you hear the correct setting, press
CLOCK to move to the next setting.
To check day and time
You can press
CLOCK at any time to hear the cur-
rent day & time without changing it.
NOTES:
1. You can press and hold SKIP or REPEAT to increase
or decrease the minute or year by increments of 10.
2. Caller ID provides the time and date. Set the year so that
the day of the week can be calculated from the caller ID
information. After you set the time once, it will always be
set automatically with incoming caller ID information. The
time will be set automatically only if you subscribe to caller
ID service provided by your local telephone company (page
30).
1.
Press
CLOCK
The system will announce
the current clock setting,
then announces "To set the
clock, press
CLOCK
."
2.
Press
CLOCK
3.
Press
SKIP
or
REPEAT
4.
until the system announces
the correct hour, then press
CLOCK
.
until the system announces
the correct minutes, then
press
CLOCK.
until the system announces
the correct day, then press
CLOCK
.
5.
6.
until the system announc-
es the correct year, then
press
CLOCK
. The system
announces the current clock
setting.
The system will announce
the current day setting,
then announces "To change
the day, press
SKIP
or
REPEAT
, to change the
hour, press
CLOCK
."
16
Press
SKIP
or
REPEAT
Press
SKIP
or
REPEAT
Press
SKIP
or
REPEAT