Panasonic SCNE5EG - Manual (Page 19)

19
VQT4U60
EN
GL
IS
H
Listening to the radio
You can preset up to 30 channels.
Preparation
≥ Make sure that the antenna is connected. ( l 8)
≥ Turn this system on.
≥ Press [CD/RADIO] repeatedly to select “FM”.
≥ A station previously stored is overwritten when another
station is stored in the same channel preset.
1
Press [PLAY MENU] to select “A.PRESET”.
2
Press [3, 4] to select “LOWEST” or “CURRENT”
and then press [OK].
LOWEST:
To begin auto preset with the lowest frequency
(FM 87.50).
CURRENT:
To begin auto preset with the current frequency.*
* To change the frequency, refer to “Manual tuning and
presetting”.
The tuner starts to preset all the stations it can
receive into the channels in ascending order.
Preparation
1 Press [PLAY MENU] repeatedly to select
“TUNEMODE”.
2 Press [ 3, 4] to select “PRESET” and then press
[OK].
Press [:/6] or [5/9] to select the channel.
∫ Manual tuning and presetting
Select a radio broadcast.
1 Press [PLAY MENU] repeatedly to select
“TUNEMODE”.
2 Press [3, 4] to select “MANUAL” and then press
[OK].
3 Press [:/6] or [5/9] to tune to the
required station.
≥ To start automatic tuning, press and hold [:/6],
[5/9] until the frequency starts scrolling. Tuning
stops when a station is found.
To preset the channel
4 While listening to the radio broadcast
Press [OK].
5 Press [3, 4] to select the channel and then press
[OK].
∫ To improve FM sound quality
1 While receiving FM broadcasts, press
[PLAY MENU] repeatedly to select “FM MODE”.
2 Press [3, 4] to select “MONO” and then press
[OK].
≥ This setting can be preset and memorised. To do so,
continue to step 4 of “Manual tuning and presetting”.
≥ Select “STEREO” in step 2 to return to stereo broadcasts.
≥ “MONO” is cancelled if the frequency is changed.
≥ If “MONO” is selected, regardless of the type of signal this
system is receiving, “FM MONO” is displayed. (l below)
∫ To display the current signal status
Press [PLAY MENU] to display “FM STATUS” and then
press [OK].
∫ To display RDS text data
Press [DISPLAY, iPod MENU] to display the text data.
≥ Each time you press the button:
≥ “STEREO” is displayed when this system tunes to a stereo
broadcast.
≥ This system can display the text data transmitted by the radio
data system (RDS) available in some areas. (RDS displays
may not be available if reception is poor.)
Presetting stations automatically
Listening to a preset channel
“FM ST”: The FM signal is in stereo.
“FM”:
The FM signal is in monaural.
≥ “FM” is also displayed even if this system is not tuned to
a station.
“PS”: Programme service
“PTY”: Programme type
“FREQ”: Frequency display
SC-NE5~VQT4U60.book 19 ページ ２０１３年１月２２日 火曜日 午後１時３８分