Panasonic SCNE5EG - Manual (Page 11)

11
VQT4U60
EN
GL
IS
H
With this method you will share the wireless network
settings of your iPod touch/iPhone/iPad with this
system.
≥ The following explanations are based on an iPhone.
1
Disconnect any devices connected to the CD unit.
2
Connect the iPhone to your home wireless
network.
3
Connect the iPhone to the CD unit.
Choose one of the following connections.
“IPOD_DOCK” connection compatible iPod touch/
iPhone:
iPod touch/iPhone/iPad with iOS 5.0 or later:
Connect to the iPod port on the side of the CD unit
with a dedicated USB cable.
4
Unlock your iPhone and then press and hold
[sNETWORK SETUP] on the CD unit for more
than 3 seconds.
≥ If “NOT SUPPORTED” or “SET WI-FI” is displayed,
check that the iPhone is connected to the wireless
network and try again from step 1.
5
A message will pop-up on your iPhone.
Allow the iPhone to share the wireless network
settings.*
1
{. The Wi-Fi status indicator blinks.
6
The settings are completed when “SUCCESS” is
displayed and the Wi-Fi status indicator stops
blinking and lights in blue.
7
Press [OK] on the remote control to exit the
settings.
*1: Depending on the network environment or the wireless
network router settings, it may take more than 10 mins. to
complete the settings.
Method 2
If you're using an iPod touch/iPhone/iPad.
(iOS version 5.0 or later.)
If “FAIL” is displayed press [OK] and try the setting
again. If “FAIL” is still displayed, try other methods on
page 10 or 12.
≥ If the iPhone was disconnected midway through, try again
without disconnecting it.
SC-NE5~VQT4U60.book 11 ページ ２０１３年１月２２日 火曜日 午後１時３８分