Advantech PENTIUM PPC-150 - Manual (Page 151)

Chapter 10 Touchscreen 135
STEP 3 - MODIFY CONFIG.SYS
MonitorMouse for OS/2 is installed by commands in CONFIG.SYS. Use
your system editor to make these changes. In general, the changes are as
follows:
1. Comment-out the existing DEVICE command(s) for your mouse.
2. Add a DEVICE command for the appropriate MonitorMouse for the
OS/2 touchscreen driver immediately after the commented-out
DEVICE commands(s).
3. Add a new DEVICE command for MOUSE.SYS.
The order of the DEVICE commands is important. Other changes may be
required depending on your hardware configuration and version of OS/2.
Serial Touchscreen Controller on PC Bus System
Change your CONFIG.SYS file as follows:
Rem C:/OS2\MOUSE.SYS {Flags}
Device=c:\elo\monmou01.sys ,
port>,
Device=c:\os2\mouse.sys stype=elomou$ {Flags -
keep same as above}
Where:
is:
2300 for the IntelliTouch E281-2300 serial controller.
4002 for the IntelliTouch E281{A}-4002 serial controller.
2210 for the AccuTouch E271-2210 serial controller.
140 for the AccuTouch E271-140 serial controller.
is:
the number of the COM port where the serial output of the touchscreen
controller is connected.
matches the switch or jumper settings on the controller.