Advantech PENTIUM PPC-150 - Manual (Page 149)

Chapter 10 Touchscreen 133
10.2.4 Installation for OS/2 (MonitorMouse)
BEFORE YOU BEGIN
First be sure OS/2 is installed and operating properly with your mouse. As
you will be modifying the CONFIG.SYS file, it is best to have the OS/2
installation disks or a bootable DOS disk readily available. This way, any
problems in CONFIG.SYS which cause the system not to boot can be
corrected by rebooting from the disk(s).
Five steps are required when installing MonitorMouse for OS/2:
Step 1 - Configure your Controller
Step 2 - Copy the Software
Step 3 - Modify CONFIG.SYS
Step 4 - Install the Touchscreen Control Panel
Step 5 - Calibrate the Touchscreen
STEP 1 - CONFIGURE YOUR CONTROLLER
Verify your controller configuration. Elo typically ships touchscreen
controllers preconfigured for use with Elo software, including
MonitorMouse for OS/2. Configuration requires setting switches and/or
installing jumpers that determine controller operating parameters. You will
need these parameters when you install the MonitorMouse for OS/2 driver
software. For controller installation instructions, refer to the IntelliTouch
Product Manual or the AccuTouch Product Manual.