Asus A8V - Manual (Page 112)

5-14 Chapter 5: Software support
Create Array
1. From the VIA RAID BIOS utility main menu, select Create Array then
press . The main menu items on the upper-left corner of the
screen are replaced with create array menu options.
RAID 0 for performance
1. From the create array menu, select Array Mode, then press .
The supported RAID configurations appear on a pop-up menu.
2. Select RAID 0 for performance then press .
From this point, you may choose to auto-configure the RAID array by
selecting Auto Setup for Performance or manually configure the
RAID array for stripped sets. If you want to auto-configure, proceed to
the next step, otherwise, skip to step 5.
3. Select Auto Setup for Performance and press . The
following confirmation message appears.
RAID 1 for data protection
RAID 0/1
RAID SPAN for capacity
RAID 0 for performance
Auto create array will destroy all
data on disks, Continue? (Y/N)
Auto Setup For Data Security
Array Mode RAID 1 (Mirroring)
Select Disk Drives
Start Create Process
VIA Tech. RAID BIOS Ver 1.xx
Create a RAID array with
the hard disks attached to
VIA RAID controller
F1 : View Array/Disk Status
↑
,
↓
: Move to next item
Enter : Confirm the selection
ESC
: Exit
Channel Drive Name Array Name Mode Size(GB) Status
Serial_Ch0 Master XXXXXXXXXXX ARRAY 0 SATA 999.99 XXXXXXX
Serial_Ch1 Master XXXXXXXXXXX ARRAY 0 SATA 999.99 XXXXXXX