Assembly, Assembl y – Alamo A84B User Manual

Page 90

ASSEMBLY

A84B 03/07

Assembly Section 3-12

ASSEMBL

JACKSHAFT BEARING SUPPORT ASSEMBLY (FIGURE -PULL TYPE)

Attach the Jackshaft bearing support bracket (1) to the tongue. Loosely attach bearing support by using pivot

bolt (3) with bushing (6).Be sure that bearing supports are essential through the front hole closest to clevis on

the tongue. Install Bearing and housing assembly (4). Install spacers (5) and bolt (2) leaving installed loosely.

Tighten bolt (2) NOTE: Do not tighten to point of collapsing spacer (5). Tighten pivot bolt (3) NOTE: Do not over

tighten. Make sure Carrier Bearing (4) pivots in supports and complete assembly pivots on lower bolt. Slide

Jackshaft through bearing (4) slide spacer (7) on Jackshaft (NOTE: Spacer goes between bearing and Quick

Disconnect Yoke.) See parts pages for Jackshaft Bearing Support prior to Serial # 10705

NOTE: ALL Yokes must be set as shown for proper phasing.