Recommendations on installation, When using the tabletop stand – Sony FWD-S42E1 User Manual
Page 48
8
GB
Recommendations on
Installation
Provide an ample amount of space around
the display
• To prevent internal heat buildup from sealing off the
display, make sure to ensure proper ventilation by leaving
open the minimum amount of space around the display, as
illustrated below.
• The ambient temperature must be 0 °C to 40 °C (32 °F to
104 °F). Be careful when installing the display near a
ceiling. The temperature there can become much higher
than the normal, lower-level room temperature.
• When using the stand, you use the applicable Tabletop
Stand SU-S01 (not supplied).For the fitting method, see
the instruction manual of the Tabletop Stand.
• Regarding the installation of hardware such as brackets,
screws, or bolts, we cannot specify the products. Actual
installation is up to the authorized local dealers. Consult
with qualified Sony personnel for installation.
• While the display is on, a certain amount of heat builds up
inside. This can cause burns. Avoid touching the top or
rear of the display when it is powered on or just after it has
entered standby mode.
When using the Tabletop Stand
• When moving or installing the display when it is attached
to the stand (not supplied), do so with at least 2 people.
• When a VESA mount compatible stand or the like is
installed, the recommended value for the screw tightening
torque is 2N·m (20kgf·cm).
When mounting the display horizontally
When mounting the display vertically
Notes
Front
Side
Units: cm (inches)
25 (9
7
/
8
)
10
(4
)
10
(4
)
10 (4
)
Front
Side
25 (9
7
/
8
)
10
(4
)
10
(4
)
25 (9
7
/
8
)
5 (2
)
Units: cm (inches)
Front
Side
Make sure
that the 1
button is at
the lower left.
20 (7
7
/
8
)
25
(9
7
/
8
)
25
(9
7
/
8
)
10 (4
)
Units: cm (inches)
5 (2
)