Sony PCV-E314DS - Manual (Page 54)

VAIO Digital Studio Reference Manual 46
9 Slide the new drive into the drive holder and align the holes on each
side of the drive holder.
10
Secure the drive to the drive holder using any two of the three holes
on each side of the drive holder (screws are provided with the new
drive). Do not overtighten the screws.
11 Connect the second drive connector to the new drive.
12 Connect the second power connector to the new drive.
13
Make sure the drive cable is connected securely to the motherboard.
14
Place the drive holder against the inside of the front chassis and slide
the drive holder back. Be sure to align the slots (A) on the drive
holder with the tabs (B) on the inside of the chassis. Be sure to slide
KY0083.VSD
Align
holes
KY0085.VSD
Second power connector
Second drive connector