Sony SU-HS2 - Manual (Page 4)

1
A
B
A
B C
D
2
3
4
4
English
The SU-HS2 is a Projector Stand for the Video Projector
only. Assemble the Projector Stand and adjust as follows:
Assembling the Projector Stand A
Before assembling
Remove the adjuster table mounted on the Video Projector.
To remove it, refer to the Video Projector Operating
Instructions.
1
Turn the stopper securing the lower and upper support
parts, remove the lower support part, pass the lower
support part through the hole in the pedestal, then
secure it with the supplied 4 screws.
2
Mount the upper support part on the lower support part,
then fix it temporarily with the stopper in the lower
position
1) as shown in the illustration. Then, pass an AC
power cord and PJ Multi cable through the lower
support
2) .
1) If the upper support part is fixed in the high position on the lower
support part, the cables may not pass through the supports.
2) Pull out an AC power cord and PJ Multi cable from the groove at
the top of the upper support for 20 to 30 cm so that they reach the
projector.
3
Adjust the upper support part to your preferred height,
then secure it with the stopper.
4
Mount the projector on the projector mounting plate and
turn until it clicks.
5
Connect the cables passed through the supports to the
projector.
Adjusting the adjuster B
Using the adjuster of the projector, you can adjust the
projecting picture position.
Hold down and slide the adjuster stopper to the right, move
the projector, then return the stopper.
You can move the projector vertically and horizontally
within the following ranges:
A
Up to 30 ° each way from the horizontal
B Up to 10 ° each way from the vertical
Adjusting the height of the supports
C
You can adjust the height of the supports within the
following range:
65 to 80 cm (Distance between the center of the lens and the
floor)
Removing the projector
D
1
Turn the projector counterclockwise while pushing the
projector lock knobs on the bottom of the projector
mounting plate inwards.
2
Lift the projector and remove it.
Specifications
Dimensions: 420 Ч 420 Ч 750mm (W × D × H)
Mass: Approx. 5.5 kg (13 lb)
Adjuster stopper
Pedestal
Lower
support
Upper support
Stopper
Projector
mounting
plate
Adjuster
Stopper
65 - 80 cm