Sony PCV-RX742 - Manual (Page 74)

To Install an AGP Add-on card
Your computer has one open AGP expansion slot. This slot enables you to install an AGP card to enhance your system's
graphics capabilities. The length of the AGP card should not exceed 9.05 inches.
Installing an AGP card disables the internal graphics. Your system supports graphics cards that use AGP 4X standards.
Observe the proper safety precautions when you upgrade your Sony computer. See Before you upgrade your
computer .
Installing an AGP card
1. Shut down your computer and turn off all peripheral devices, such as your printer.
2. Unplug your computer and any peripheral devices.
3. Remove the side cover. See Removing the side cover .
4. Locate the AGP card slot and remove the slot cover. Press down on the end latch before inserting the AGP card.
Locating the AGP card slot
5. Firmly insert the AGP card into the slot. Lift up the end latch, if the latch does not automatically lock back into
place.
6. Secure the AGP card with the screw.
7. Replace the side cover. See Replacing the side cover .
8. Reconnect all peripheral devices and the power cord.
9. Connect your monitor cable to the monitor port on the newly installed AGP card.
10. Turn on your computer and install the driver for the AGP card. See the instructions that came with the AGP card.
Page 74