Sony STR-DH820 - Manual (Page 38)

38 GB
D:\SONY job\STR-DH820_PMRF_02\GB\4266497121\GB04GET_STR-DH820-CEL.fm masterpage: Left
STR-DH820
4-266-497-11(2)
1
Press GUI MODE.
After “GUI ON” appears on the display
panel for a while, the GUI menu appears
on the TV screen.
Press MENU if the GUI menu does not
appear on the TV screen.
2
Press V/v repeatedly to select
“ Settings”, then press or
b.
The Settings menu list appears on the TV
screen.
3
Press V/v repeatedly to select
“Auto Cal.”, then press or b.
4
Press B/b repeatedly to select
“Standard”, then press .
The calibration type is automatically set
to “Engineer”.
5
Press to select “START”.
6
The measurement starts in five
seconds.
The measurement process will take
approximately 30 seconds with a test
tone.
When the measurement ends, a beep
sounds and the screen switches.
Note
If an error code appears on the screen, see
“Message list after Auto Calibration
measurement” (page 40).
Performing Auto Calibration
V/v/B/b,
GUI
MODE
MENU
MASTER
VOL +/–/
2 +/–
Input
buttons
?/1
MUTING/