beautypg.com

Application, Master power switch, Control panel – ATN MK 6600 User Manual

Page 3

background image

The information in this manual furnished for information use only, is subject to change without notice, is not to be

construed as a commitment by ATN Corp.
ATN Corp. assumes no responsibility or liability for any errors or inaccuracies that may appear in this book.
©2002 ATN Corp. All right reserved.

2

APPLICATION

The Aries MK6600/6650/7700/7750/8700/8750 night vision weapon scope is a complex computer-

ized system for the observation of objects at low light levels. Containing an onboard computer these

scopes are some of the most advanced night vision weapon scopes in the world.
The Aries MK6600/6650/7700/7750/8700/8750 consists of the objective lens assembly, ocular

lens assembly and the body. The body contains the image intensifier tube assembly with the inte-

grated high voltage power source. The body also houses the electronics for the reticle, the computer

console for the “Smart Technology” as well as the battery compartment. The 100M infra-red illumi-

nator is located on the top of the unit.
The objective lens protective cover (not shown) is designed to protect the lens from scratches and

abrasions. This cover also protects the image intensifier tube from exposure to daylight or other

bright light sources. The protective cover acts as a daylight filter, note the pinhole in the center of

the lens cap.

MASTER POWER SWITCH

The Master ON/OFF switch is to be found on top of

MK6600/6650/7700/7750/8700/8750. Once the

scope’s master power is switched on you can adjust

the scope using the buttons on the control box.

CONTROL PANEL

The control box with the cluster of three buttons on it can be found on the left side of the Aries

MK6600/6650/7700/7750/8700/8750. ”SL” button acts as a three-way selection toggle. By press-

ing it once you will see one of three colored diodes located on the rear side of the control box light

up. Make sure to keep both eyes open; your right eye is expected to aim through the scope so that

your left eye perceives the changes on the rear side of the control box. “+” and “-” buttons are used

to correspondingly increase or decrease adjustments for a chosen function.
The three colored led diodes represent the scope function mode. “B” stands for brightness of the

light intensifier tube, “R”- for reticle brightness, and “I”- for IR illuminator brightness.

Brightness LED

Reticle brightness LED

Illuminator brightness LED

“+” adjustment button

“-” adjustment button

“SL” selection button

Master power switch