Sony RDH-GTK37iP - Manual (Page 24)

24 GB
Notes
• Total playing time for a USB device is not
displayed.
• The following are not displayed correctly:
– elapsed playing time of an MP3 file
encoded using VBR (variable bit rate).
– folder and file names that do not follow
either the ISO9660 Level 1, Level 2 or
Joliet in the expansion format.
• ID3 tag information for MP3 files is displayed
when ID3 version 1 and version 2 tags are
used (ID3 version 2 tag information display
has priority when both ID3 version 1 and
version 2 tags are used for a single MP3 file).
Using optional
equipment
1
Press VOLUME – repeatedly
until “VOL MIN” appears in the
display panel.
2
Connect an optional equipment
(page 11).
3
Press FUNCTION +/– repeatedly
to select the DVD/PC function.
4
Start playing the connected
equipment.
5
Press VOLUME + repeatedly to
adjust the volume.
Note
The system may enter standby mode
automatically if the volume level of the
connected equipment is too low. Adjust the
volume level of the equipment. To turn off
automatic standby function, see “Setting/
Canceling the automatic standby function”
(page 24).
Deactivating the
buttons on the unit
(Child Lock)
You can deactivate the buttons on the unit
(except "/1) for preventing
misoperation, such as child mischief.
Hold down x on the unit for more
than 5 seconds.
“CHILD” and “LOCK ON” appear in the
display panel.
You can only operate the system using the
buttons on the remote control.
To cancel, hold down x on the unit for
more than 5 seconds until “CHILD” and
“LOCK OFF” appear in the display panel.
Note
Child Lock function will be canceled when you
disconnect the power cord.
Setting/Canceling the
automatic standby
function
This system is equipped with an
automatic standby function. With this
function, the system enters standby mode
automatically in about 30 minutes when
there is no operation or audio signal
output.
By default, the automatic standby
function is turned on.
1
Press OPTIONS.
2
Press / repeatedly to select
“AutoSTBY”, then press .
3
Press / repeatedly to select
“ON” or “OFF”.