Sony DCM-M1 - Manual (Page 19)

The necessary settings of your PC are over. Next, let's make
settings for the MD DISCAM.
1. Select "ADVANCED" - "PC CONNECT" - "SET UP"
from the menu of the MD DISCAM.
2. Select "Automatic".
3. Select "EXEC" and restart the MD DISCAM.
4. When the MD DISCAM restarts, select "ADVANCED"
- "PC CONNECT" - "CONNECT" from the menu.
5. In a little while, the display changes to the window as
shown on the left.
*If the message "Failed in obtaining an address
automatically" shows up:
The MD DISCAM failed in
obtaining an address with the DHCP. In that case, check if
the network cable is connected properly Then, turn off the
MD DISCAM, wait for about 10 seconds, turn it on and try
connecting again.
The settings of the MD DISCAM are now over. Now try to
access the MD DISCAM from the PC.
Back to MD DISCAM Top page