Asus P5B-VM DO - Manual (Page 82)

2-28 Chapter 2: BIOS setup
Onboard 1394 Cotroller [Enabled] [Enabled]
Allows you to enable or disable the onboard IEEE 1394 controller.
Configuration options: [Enabled] [Disabled]
Onboard LAN [Enabled]
Allows you to enable or disable the onboard LAN controller.
Configuration options: [Enabled] [Disabled]
LAN Option ROM [Disabled]
Configuration options: [Disabled] [Enabled]
JMicron SATA/PATA Controller [Enabled]
Allows you to enable or disable the JMicron SATA/PATA controller.
Configuration options: [Enabled] [Disabled]
JMicron Controller Mode [Basic]
Configuration options: [RAID] [BASIC] [AHCI]
Serial Port1 Address [3F8/IRQ4]
Allows you to select the Serial Port1 base address.
Configuration options: [Disabled] [3F8/IRQ4][2F8/IRQ3] [3E8/IRQ4] [2E8/IRQ3]
Parallel Port Address [378]
Allows you to select the Parallel Port base addresses.
Configuration options: [Disabled] [378] [278] [3BC]
Parallel Port Mode [ECP]
Allows you to select the Parallel Port mode.
Configuration options: [Normal] [Bi-directional] [EPP] [ECP]
ECP Mode DMA Channel [DMA3]
Appears only when the Parallel Port Mode is set to [ECP]. This item
allows you to set the Parallel Port ECP DMA.
Configuration options: [DMA0] [DMA1] [DMA3]
Parallel Port IRQ [IRQ7]
Configuration options: [IRQ5] [IRQ7]
Must load the JMB363 driver when creating RAID sets, even if all the drivers of
the RAID sets are used as data drivers.