Asus P5B-VM DO - Manual (Page 50)

1-38 Chapter 1: Product introduction
12. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default , the pin labeled “Chassis Signal” and “ Ground” are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
13. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that
supports either HD Audio or legacy AC`97 audio standard. Connect one end
of the front panel audio I/O module cable to this connector.
• We recommend that you connect a high-definition front panel audio module
to this connector to avail of the motherboard’s high-definition audio capability.
• By default, this connector is set to [HD Audio]. If you want to connect a AC’
97 front panel audio module to this connector, set the Front Panel Support
Type item in the BIOS setup to [AC97]. See section 2.4.6 Onboard Device
Configuration for details.
R
CHASSIS
+5VSB_M
B
Chassis Signal GND
(Default)
P5B-VM DO
P5B-VM DO Chassis Intrusion connector
R
P5B-VM DO
HP_HD
MIC2_L
HP_R
HP_L
MIC2_JD
Jack_Sense
MIC2_R PRESENSE#
AGND
AAFP
Legacy AC 97-compliant
pin definition
NC
MIC2_L
Line out_R
Line out_L
NC
NC
MIC2_R NC
AGND
Azalia-compliant
pin definition
P5B-VM DO Front panel audio connector