AASTRA 6757i CT RP - Manual (Page 26)

20 Model 6757i CT RP Phone Installation Guide
Installation and Setup – 6757i CT RP Cordless
Note: The battery must be charged for a minimum of six hours prior to initial usage
of the handset.
Belt Clip
To install the belt clip, snap one arm of the clip into the slot on the side of
the handset and then slide the other arm into the slot on the other side of
the handset until it snaps into place.
Using a Headset with your Telephone
The 6757i CT RP cordless handset accepts headsets through the jack on the
bottom of the handset. Contact your telephone equipment retailer or
distributor to purchase a compatible headset. Customers should read and
observe all safety recommendations contained in headset operating guides
when using any headset.
Battery Status Icons
The display provides “at a glance” information on the handset battery:
Note: The handset is designed to recharge the batteries automatically, when
required and placed on the charger stand. The battery icon will not flash and
the handset does not charge every time it is placed on the stand. If a defective
battery is replaced, then the battery icon is not identified until the new battery
is charged for at least 2 minutes.
d
c
b
a
The bars indicate the bat-
tery charge level — 4 for
full, needs recharging
when only 1 bar appears.
f
The bars will flash when
the battery is being
recharged on the charger
stand.
Handset
(face down)