AASTRA 6757i CT RP - Manual (Page 24)

18 Model 6757i CT RP Phone Installation Guide
Installation and Setup – 6757i CT RP Base Unit
Install on the Wall
The 6757i CT RP phone has two pre-drilled wall mounting holes on the
back of the phone. Using the provided wall mount drilling template, locate
and mark the position for the mounting screws on the wall. Depending on
the wall type, you may need to use wall anchors. Both the screws and wall
anchors are included with your phone.
Place the wall mount holes on the phone over the screw heads on the wall
and pull down to lock the phone in.
Note: You may wish to purchase a short Ethernet cable from a local supplier for a
wall installation. Also, if 802.3af compliant in-line power is not provided on
your network, and you are installing the 6757i CT RP base unit on a wall
using a PoE in-line power injector, you may also wish to use an equivalent
flat Ethernet cable rather than the one provided.
Wall Mount Holes