Sony MHC-BX2 - Manual (Page 9)

9
To erase a preset station
1 Keep pressing TUNER MEMORY until a
preset number appears in the display.
2 Turn the shuttle until it clicks to select the
preset number you want to erase.
Select “ALL ERASE” when you want to
erase all the preset stations.
3 Press ENTER.
“COMPLETE” appears in the display.
When you erase a preset number, the preset
number decreases by one and all preset
numbers following the erased one are
renumbered.
To change the AM tuning interval
(Except for the European and Middle
Eastern models)
The AM tuning interval is factory-preset to 9 kHz
(10 kHz in some areas). To switch the AM tuning
interval, tune in any AM station first, then turn off
the power. While holding down TUNER/BAND,
turn the power back on. When you change the
interval, AM preset stations are erased. To switch
back to the original interval, repeat the same
procedure.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or a power failure
occurs.
DISPLAY
Saving the power in
standby mode
(MHC-BX2 only)
You can lower the power consumption to a
minimum (Power Saving Mode) and save
energy in the standby mode.
?/1
(Power)
VOLUME
ALL DISCS
ß
, Press DISPLAY repeatedly when the
power is off. Every time you press
the button, the system switches as
follows:
t Demonstration t Clock
Power Saving Mode T
The system is turned on/off by pressing
?/1
.
Tips
• ?/1 indicator and timer indicator (when the timer
is set) light even in the Power Saving Mode.
• The timer functions in the Power Saving Mode.
Note
You cannot set the time in the Power Saving Mode.
To cancel the Power Saving Mode
Press DISPLAY once to show the
demonstration, twice to show the clock
display.