Sony MHC-BX5 - Manual (Page 39)

39
Connecting a VCR
Make sure to match the color of the plugs and
the connectors. To listen to the sound of the
connected VCR, hold down MD (VIDEO) and
press ?/1 when the power is turned off. This
switches the “MD” function to “VIDEO”.
Once you enable the “VIDEO” function, just
press MD (VIDEO).
By connecting the audio output jacks of your
VCR to the MD/VIDEO (AUDIO) jacks using
an optional audio cable, you can enjoy video
playback in powerful stereo sound.
Note
• You cannot switch from MD to VIDEO or from
VIDEO to MD when the system is in the Power
Saving Mode (see page 9).
• If the sound is distorted or too loud when
selecting “VIDEO”, or you want to switch back to
“MD”, repeat the operation described above for
switching to “MD”.
To the audio output of the VCR
Tip
When you connect a Sony MD deck, you can use the
MD N, X, and x buttons on this unit’s remote to
perform play, pause, and stop operations.
Note
If you cannot select “MD” even when you have
pressed MD (VIDEO), press ?/1 while pressing MD
(VIDEO) when the power is turned off. “VIDEO”
will be switched to “MD”. To return to “VIDEO” do
the same procedure. However, you cannot switch
from MD to VIDEO or from VIDEO to MD when the
system is in the Power Saving Mode (see page 9).