Sony SHAKE5 - Manual (Page 27)

model name [SHAKE-5]
[4-462-816-12(1)] GB
27 GB
filename[D:\NORM'S JOB\SONY HA\SO130030\SHAKE-5 (PMRF
02)\4462816121_GB\07OTH.fm] masterpage:Right
Ot
he
r Op
er
a
tio
ns
3
Press / repeatedly to select
“PLAY SET” or “REC SET”, then
press .
4
Set the time to start playback or
transferring.
Press / repeatedly to set the hour/
minute, then press .
5
Use the same procedure as in
step 4 to set the time to stop
playback or transferring.
6
Press / repeatedly to select
the sound source you want, then
press .
For Recording Timer:
Connect a transferable USB device to
the B
port.
7
Press "/1 to turn off the system.
To check the timer setting or
activate the timer again
1 Press TIMER MENU.
“TIMER SELECT” flashes in the
display panel.
2 Press .
3 Press / repeatedly to select
“PLAY SELECT” or “REC
SELECT”, then press
.
To cancel the timer
Repeat the same procedure as above and
select “TIMER OFF” in step 3, and then
press .
Notes
• The system turns on before the preset time. If
the system is turned on at the preset time or if
“STANDBY” flashes in the display panel, the
Play Timer and the Recording Timer will not
play or transfer.
• Do not operate the system from the time the
system turns on until the playback or transfer
starts.
Changing the display
Press DISPLAY repeatedly while
the system is turned off.
Demonstration
The display changes and the indicator
flashes even when the system is turned
off.
No display (Power Saving Mode)
The display is turned off to conserve
power. The timer and clock continue to
operate.
Clock
The clock display automatically turns to
Power Saving Mode after a few seconds.
1
Press OPTIONS on the unit.
2
Press / repeatedly to select
“SPECTRUM”, then press .
3
Press / repeatedly to select
the spectrum pattern you want,
then press
.
To exit the options menu, press
OPTIONS on the unit.
Changing the display mode
Changing the spectrum
pattern of the display panel