beautypg.com

Troubleshooting – Sony VPL-5400ES User Manual

Page 54

background image

54

D:\job\3218492111\3218492111VPLVW60UC\010GB_VPLVW60UC\0
8OTH.fm

masterpage:Left

VPL-VW60

3-218-492-11 (1)

Troubleshooting

If the projector appears to be operating erratically, try to diagnose and correct the problem
using the following instructions. If the problem persists, consult with qualified Sony
personnel.

Power

Picture

Symptom

Cause and Remedy

The power is not turned on.

c After about one minute, turn the power on.
c Close the lamp cover securely, then tighten the screws securely.

(

1 page 58)

c Close the filter holder securely. (1 page 60)
c Check warning indicators. (1 page 56)

Symptom

Cause and Remedy

No picture.

c Check that the proper connections have been made.

(

1 page 17)

c Select the input source correctly using the INPUT button.

(

1 page 27)

c Set the computer signal to output from an external monitor.
c Set the computer signal to output only to an external monitor.
c Select “Computer,” “Component” or “Video GBR” for “Input-A

Signal Sel.” on the Setup

menu according to the input

signal. (

1 page 47)

The picture from the
INPUT A connector is
colored strange.

c Select “Computer,” “Component” or “Video GBR” for “Input-A

Signal Sel.” on the Setup

menu according to the input

signal. (

1 page 47)

The picture from the
VIDEO INPUT or
S VIDEO INPUT
connector is colored
strange.

c Adjust the picture of the Picture

menu. (

1 page 40)

c Set “Color System” in the Setup

menu to match the color

system being input. (

1 page 47)

The color gradation of the
dark area or the bright area
of the picture from the
HDMI 1 or HDMI 2
connector becomes
unclear.

c The color gradation of the dark area or the bright area may

become unclear when a signal other than those from HDMI
standard is input. Adjust the “Brightness” and the “Contrast” in
the Picture

menu. (

1 page 41)

The picture is too dark.

c Adjust the “Contrast” or “Brightness” of the Picture

menu

properly. (

1 page 41)

The picture is not clear.

c Adjust the focus. (1 page 24)
c Condensation has accumulated on the lens. Leave the projector

for about two hours with the power on.

00COV.book Page 54 Thursday, June 21, 2007 1:05 PM

This manual is related to the following products: