Sony VPL-5400ES - Manual (Page 27)

27
Proj
ect
in
g
This section describes how to operate the projector to view the picture from the equipment
connected to the projector. It also describes how to adjust the quality of the picture to suit
your taste.
Projecting the Picture on the Screen
* Set the “Input-A Signal Sel.” setting in the Setup menu according to the signal input. When
you set it to “Auto,” and cannot display the picture properly, select an appropriate signal
according to the input signal. (
1 page 47, 52)
** The color gradation of the dark area or the bright area may become unclear when a signal other
than those from HDMI standard is input. Adjust the “Brightness” and the “Contrast” in the
Picture
menu. ( 1 page 41)
Projecting
1
Power on both the equipment
and the device connected to the
equipment.
2
Press INPUT repeatedly to
select the input you want to
project on the screen.
Display the indication of the input you
want.
Example: To view the picture
from the video
equipment connected
to the VIDEO INPUT
connector.
To view the picture from Press INPUT to display
Video equipment connected to the VIDEO INPUT connector Video
Video equipment connected to S VIDEO INPUT connector S-Video
Component equipment connected to Y P
B
/C
B
P
R
/C
R
on the projector Component
RGB/component equipment connected to the INPUT A connector Input-A*
Equipment connected to the HDMI 1 connector HDMI1**
Equipment connected to the HDMI 2 connector HDMI2**