Sony DCR-PC110 - Manual (Page 12)

12
Charging time
Battery pack Full charge (Normal charge)
NP-FM50 (supplied) 150 (90)
NP-FM70 240 (180)
NP-FM90 330 (270)
NP-FM91 360 (300)
Approximate minutes to charge an empty battery pack
Recording time
Recording with Recording with
Battery pack the viewfinder the LCD screen
Continuous* Typical** Continuous* Typical**
NP-FM50 (supplied) 135 (120) 80 (70) 115 (105) 65 (60)
NP-FM70 285 (255) 170 (150) 245 (220) 145 (130)
NP-FM90 435 (390) 260 (230) 370 (335) 220 (200)
NP-FM91 505 (455) 300 (270) 430 (390) 255 (230)
Approximate minutes when you use a fully charged battery
Numbers in parentheses “( )” indicate the time using a normally charged battery.
* Approximate continuous recording time at 77°F (25°C). The battery life will be
shorter if you use your camcorder in a cold environment.
** Approximate number of minutes when recording while you repeat recording start/
stop, zooming and turning the power on/off. The actual battery life may be shorter.
Playing time
Battery pack
Playing time Playing time
on LCD screen with LCD closed
NP-FM50 (supplied) 140 (125) 170 (155)
NP-FM70 295 (265) 355 (320)
NP-FM90 450 (400) 540 (485)
NP-FM91 520 (465) 625 (560)
Approximate minutes when you use a fully charged battery
Numbers in parentheses “( )” indicate the time using a normally charged battery.
The battery life will be shorter if you use your camcorder in a cold environment.
What is ”InfoLITHIUM”?
The “InfoLITHIUM” is a lithium ion battery pack which can exchange data such as
battery consumption with compatible electronic equipment. This unit is compatible
with the “InfoLITHIUM” battery pack (M series). Your camcorder operates only with
the “InfoLITHIUM” battery. “InfoLITHIUM” M series battery packs have the
SERIES
TM
mark.
“InfoLITHIUM” is a trademark of Sony Corporation.
If the power may go off although the battery remaining indicator indicates that
the battery pack has enough power to operate
Charge the battery pack fully again so that the indication on the battery remaining
indicator is correct.
Step 1 Preparing the power supply