Setting up the remote, Controlling tvs with the remote – Sony RDR-GX7 User Manual
Page 26
26
Setting Up the Remote
To check the channel settings
When displaying the “Set VCR Plus+ Channels” menu, press
M/m to select “Channel List,” then press ENTER.
The display lists the channels whose guide channel number is not
as same as the TV channel number.
To go to the next page, press
m.
To return to the previous page, press
M.
Setting Up the Remote
You can control your TV with the supplied remote by adjusting
the remote control’s signal.
If you connected the recorder to an AV amplifier (receiver), you
can also control the volume with the supplied remote.
Notes
• Depending on the connected unit, you may not be able to control your
TV or AV amplifier (receiver) with some or all of the buttons below.
• If you enter a new code number, the code number previously entered
will be erased.
• When you replace the batteries of the remote, the code number may be
reset to the default setting. Set the appropriate code number again.
Controlling TVs with the remote
a Slide the TV/DVD switch to TV.
b Hold down [/1.
c Enter your TV’s manufacturer code (see
“Code numbers of controllable TVs” below)
using the number buttons.
d Release [/1.
When the TV/DVD switch is set to TV, the remote
performs the following:
Settings - VCR Plus+ Channel List
Guide CH
TV CH
2
4
6
10
11
25
28
-
-
-
-
-
-
-
21
32
9
121
13
36
2
Guide CH
TV CH
45
53
- -
- -
- -
- -
- -
-
-
-
-
-
-
-
18
5
- -
- -
- -
- -
- -
Close
Page2
[/1
Turns your TV on or off
VOL +/–
Adjusts the volume of your TV
CH +/–
Selects the channel on your TV
WIDE MODE
Switches to or from the wide mode of a
Sony wide-screen TV
TV/VIDEO
Switches your TV’s input source
Number buttons and
SET
Selects the channel on your TV
TV/DVD switch
"
/
1
VOL +/–
Number buttons,
SET
TV/VIDEO
WIDE MODE
CH +/–