Sony VPL-VW12HT - Manual (Page 14)

14
(GB)
Remote Commander
Keys which have the same names as those on the
control panel function identically.
1 I (ON) key
Press this key to turn on the projector. (It is assumed
that the projector is in the standby mode.)
2 1 (OFF) key
Press this key to turn off the power immediately.
3 INPUT SELECT keys
Select the input signal.
VIDEO: Selects the signal of equipment connected
to the projector’s VIDEO connector.
S VIDEO: Selects the signal of equipment
connected to the projector’s S VIDEO connector.
A: Selects the video signal of equipment connected
to the INPUT A connectors.
B: Selects the video signal of equipment connected
to the INPUT B connectors.
Location and Function of Controls
MUTING
INPUT SELECT
VIDEO MEMORY
PIC
VIDEO
S VIDEO
A
1 2 3
4
OFF
MENU
ENTER RESET
PROJECTOR
5 6
B
RM-PJVW10
1
3
4
5
6 7
8
9
0
qa
qsqd
2
5 CONTROL S IN (PLUG IN POWER) (DC 5V
output) jack (stereo minijack)
Connects to the control S out jacks of Sony
equipment.
Connects to the CONTROL S OUT jack on the
supplied Remote Commander when using it as a wired
remote control. In this case, you do not need to install
batteries in the Remote Commander, since power is
supplied from this jack.
If this connector is used, the Remote Commander key
lamp is not turned on.
6 VIDEO IN connectors
Connect to external video equipment such as a VCR.
S VIDEO (mini DIN 4-pin): Connects to the S video
output (Y/C video output) of video equipment.
VIDEO (phono type): Connects to the composite
video output of video equipment.