Connector panel, 1input a connectors g/y, b/c, Hdtv or dtv (dtv gbr, dtv yp – Sony VPL-VW12HT User Manual
Page 13: Signal is selected. 2 input b connectors g/y, b/c
13
(GB)
Connector Panel
1
INPUT A connectors
G/Y, B/C
B
/P
B
, R/C
R
/P
R
, SYNC/HD, VD connectors
(phono type):
Connect to the RGB output of the equipment.
According to the connected equipment, computer,
component (Y/C
B
/C
R
), HDTV or DTV (DTV GBR,
DTV YP
B
P
R
) signal is selected.
2
INPUT B connectors
G/Y, B/C
B
/P
B
, R/C
R
/P
R
, SYNC/HD, VD connectors
(phono type):
Connect to the RGB output of the equipment.
According to the connected equipment, computer,
component (Y/C
B
/C
R
), HDTV or DTV (DTV GBR,
DTV YP
B
P
R
) signal is selected.
3
REMOTE (RS-232C) connector (D-sub 9-pin,
female)
This is a service connector. When the unit is
connected to a computer via this connector, you can
adjust the gamma values of the projector from the
computer using the ImageDirector software provided
on the CD-ROM that came with the projector.
For details, see the Operating Instructions provided on the
CD-ROM that came with the projector.
4
TRIGGER connector (minijack)
Outputs the ON or OFF condition of the unit to the
external equipment.
When the unit is turned off, 0 V is output and when
the unit is turned on, 12 V is output. However, as
power is not output, you cannot use the connector as a
power source.
Left side
Location and Function of Controls
CONTROL S IN
VIDEO IN
TRIGGER
REMOTE
INPUT A
INPUT B
PLUG IN POWER
RS-232C
(FOR SERVICE USE)
S VIDEO
G/Y
B/C
B
/P
B
R/C
R/
P
R
SYNC/HD
VD
VIDEO
G/Y
B/C
B
/P
B
R/C
R/
P
R
SYNC/HD
VD
1
2
3
4
5
6
ON/STANDBY: Lights up or flashes under the
following conditions:
• Lights up in red when the AC power cord is
plugged into the wall outlet. Once in the
standby mode, you can turn on the projector
with the
I /
1 key.
• Lights up in green when the power is turned on.
• Flashes in green while the cooling fan runs after
the power is turned off with the
I /
1 key. The
fan runs for about 120 seconds after turning off
the power.
The ON/STANDBY indicator flashes quickly
for the first 40 seconds of that time.
During this first 40 seconds, you cannot turn the
power back on with the
I /
1 key.
For details on the LAMP/COVER and the TEMP/FAN
indicators, see page 44 (GB).