Sony PCG-FX390P - Manual (Page 42)

Change text in this variable definition to document title.
42
Connecting to a LAN
You can connect your notebook to 10Base-T and 100Base-TX-type Local Area
Networks (LANs). For the detailed settings and devices needed to connect to the
network, ask your network administrator.
To set up your ethernet connection
To connect to the network
1 Click Start, select My Computer, and click My Network Places under the
Other Places header.
2 Click “Add a network place” under the Network Tasks header, or click “Set
up a home or small office network,” depending on your configuration.
3 Depending on your choice, either the The Add Network Place Wizard or
Network Setup Wizard is displayed.
Connecting to LAN
Warning: Only connect 10Base-T and 100Base-TX cables to the Ethernet
port. Do not connect any other type of network cable or any telephone line.
Connecting cables other than those listed above may result in an electric
current overload and could cause a malfunction, excessive heat, or fire in the
port. To connect the unit to the network, contact your network administrator.
If you enable Wake on LAN, the power saving mode will be switched to
Standby mode.
Ethernet
port