Sony HDR-AS100VR - Manual (Page 50)

Ta
bl
e of
con
ten
ts
O
p
era
tio
n
Sea
rch
Set
tings
Se
ar
c
h
In
dex
50 GB
The Adhesive Mount is used for fixing the Waterproof Case or Tripod Adaptor to an item you
intend to use. The Adhesive Mount is a general term for the Attachment Buckle, Flat Adhesive
Mount, and Curved Adhesive Mount. Before attaching, insert the camera in the Waterproof Case
or attach the Tripod Adaptor.
Attachment method
The procedure below explains the attachment method of the Waterproof Case.
1 Align the tripod screw hole in the bottom of
the Waterproof Case with the tripod screw
hole of the Attachment Buckle, and fix firmly
with the tripod screw.
• Confirm that the assembly is fixed securely.
2 Attach the Attachment Buckle (with the
Waterproof Case set in step 1) to the Flat
Adhesive Mount or Curved Adhesive Mount by
sliding it until it clicks into place.
3 Remove dust, moisture and oily substances
completely from the surface where the Adhesive
Mount is to be attached.
4 Peel off the release paper on the back, and fix the Adhesive Mount in the
desired location.
• Adhesive power reaches its maximum strength 24 hours after the Adhesive Mount is attached to the
desired location.
Adhesive Mount (VCT-AM1)
Attachment Buckle Flat Adhesive Mount Curved Adhesive Mount
Tripod
screw
Positioning pin
z To attach to or detach from the Attachment Buckle
Press and hold the circled part to unlock, then slide it
in the opposite direction of step 2.
Continued r