American Dryer Corp. MDG-120PVV - Manual (Page 45)

113395 - 6 Maytag Co. 43
SECTION X
PROCEDURE FOR FUNCTIONAL CHECK
OF REPLACEMENT COMPONENTS
1. Microprocessor Controller (Computer) Board
a. Phase 7 Non-Coin Models
1) Upon completing installation of the replacement
microprocessor controller (computer) board,
reestablish power to the dryer.
2) Start the drying cycle by pressing any of the preset
cycles in letters A-F.
3) Verify that the applicable indicator lights on the
microprocessor controller (computer) board are
lit. (Refer to the illustration below.)