beautypg.com

Listening to the radio using the s-air connection, Listening.to.the.radio.using.the, S-air.connection – Sony AIR-SA20PK User Manual

Page 27: Using the main unit

background image

AIR-SA20PK.GB.4-117-793-11(1)

GB

Oper

ations

To use the main unit as a battery

charger

You can use the main unit as a battery

charger for the iPod when the main unit

is on.

The charging begins when the iPod

is placed on the iPod connector. The

charging status appears in the iPod

display. For details, refer to the user’s

guide of your iPod.

To stop charging the iPod, remove the

iPod or turn off the main unit.

Notes

 When placing or removing the iPod, handle

the iPod in the same angle as that of the

iPod connector on the main unit and do not

twist or sway the iPod to prevent connector

damage.

 Do not carry the main unit with an iPod

set on the connector. Doing so may cause a

malfunction.

 When placing or removing the iPod, brace

the main unit with one hand and take care

not to press the controls of the iPod by

mistake.

 Before disconnecting the iPod, pause

playback.

 You cannot adjust the volume using the main

unit.

 The volume level does not change even if

adjusted on the iPod.

 The main unit is designed for iPod only. You

cannot connect any other portable audio

players.

 Depending on the iPod model you are using

and its status, operations using the main unit

and the sub units may not be accepted or the

wrong operations may be performed.

 Sony cannot accept responsibility in the

event that data recorded to iPod is lost or

damaged when using an iPod with this S-AIR

product.

Listening to the

radio using the S-AIR

connection

Using the main unit

1

Select.the.tuner.channel.

When the S-AIR mode is set to

“PARTY”:

Press PARTY CH on the remote

repeatedly until “FM” or “AM”

appears in the display.
When the S-AIR mode is set to

“MULTI SOURCE”:

The tuner channel is internally

activated. Go to step 2.

2

Select.“FM”.or.“AM.”

Press BAND repeatedly.

3

Perform.automatic.tuning.

Press and hold TUNING +/ on

the remote (or TUNING/SELECT

+/ on the unit) until the frequency

indication changes and then release.
“AUTO” lights up in the display.

Scanning stops automatically when

a station is tuned in, and then

“TUNED” and “ST” (for FM stereo

programs only) appear.

Continued

This manual is related to the following products: