beautypg.com

System, Not arm (ready light off) – ADT Security Services Safewatch Plus Enterpreneur Security Systems User Manual

Page 6

background image

Turning Off the

Zones and Entrance Delay

Control station key 4 may be used to turn the interior zones off prior to arming. This
will allow the system to alarm instantly if the entrance door is opened, while armed.

1. Press the 4 key and hold for three seconds.

2. When interior defined zones are turned off, the corresponding Zone indicators

will flash. The flashing will stop 30 seconds after the system is armed.

3. Arm the system by entering your User Code.

Note: Upon disarming, the interior zones

your Installer has altered

feature through programming.

Automatic Interior Off/Delay Off

Your

system may have been programmed to automatically turn the interior zones

off if you arm and do not leave the premises before the exit delay time expires. The
entrance delay may also

be

programmed to automatically turn off at this time. When

the system is disarmed, the interior and delay

return to their normal on or off

state. See your security representative for details.

Two

Arming

Your system may have been programmed with an abbreviated arming feature.

When this feature is enabled, only the first two digits of your User Code will be
required to arm the system

and

perform other features. Disarming however, will still

require the entire code sequence.

If the READY indicator is off, one or more detection devices such as a door or

window has been left open. The system cannot be armed. One or more of the six

ZONE indicators will also be lighted indicating the area of protection that is at fault.
Use the pull out zone I.D. card on

control station to define the area of protection

assigned to each zone.

NOTE:

If

an attempt Is made to arm the system

the READY light off,

a

three second error tone

be

to alert you that the system did

not arm.