beautypg.com

Temp code – ADT Security Services Safewatch Plus Enterpreneur Security Systems User Manual

Page 15

background image

An optional feature of your system allows you to assign a certain number of valid
uses to User Code 6. After the code has been used the programmed amount of times,

it automatically becomes disabled. This code may be assigned to a maintenance

person, a maid, or anyone who you would like to be able to arm and disarm the

system for a selected number of times without having to give out your regular code.

After the uses have expired,

code will cease to function. It can be re-enabled by

programming in another number indicating how many times

it can be used. It

will not be necessary to re-program the actual code unless changing the code itself
is desired.

1.

2.

3.

4.

5.

6.

7.

8.

9.

The system must be disarmed.

Press key 9 and hold for three seconds. The control station will beep three times.

Enter the Master User Code. The control station will beep two times. The
READY and ARMED indicators will blink alternately and the other eight

indicators will blink in sequence with each other when the programming mode
is successfully entered (see note

Press key 6, then to instruct the control

you wish to program the desired

code sequence for User Code 6. The control station will beep three times.

Enter the desired four digit code sequence. After the fourth digit is entered, the

control station will emit one short beep followed by one long beep then the

system will exit the programming mode automatically.

Repeat step 2 to re-enter

programming mode.

Press keys 7 plus # to instruct the control that you wish to program the number
of valid uses for User Code 6. The control station will beep two times.

Enter the number of uses desired,

1

255, then press the * “key. The control

station will beep two times.

Press the * key twice to exit the programming mode.

Note:

The temporary code may

ail oft

he

of your regular

User Codes. Only the Master User

(Coda

1) will

permit entry into the

programming

mode

of operation. Remote Ptogrammlng Is not

U.L. Listed Systems.

NOTE REGARDING REMOTE PROGRAMMING:

If the ALARM indicator lightssteady after entering the programming mode,
your Installer has enabled the Remote Programming optlon. This feature
enables the installing company (or someone assigned by them) to re-

motely

and control your system.

C