ADT Security Services Safewatch Plus Enterpreneur Security Systems - Manual (Page 11)

The bypass key is used to bypass selected zones in your system. A bypassed zone
will NOT be capable of activating an alarm as it is temporarily removed from your
system. Bypassing (also referred to as shunting) is most commonly used to allow
free movement of an area (zone or group of zones) while arming the rest of the
system or to temporarily remove a zone or zones that require
service allowing
partial
use of the system until repaired. When zones are bypassed, the corresponding
ZONE indicators flash to indicate that they have been removed from operation. The
flashing will cease 30 seconds after
the exit
delay expires when the system is armed.
1.
2.
3.
4.
1.
2.
3.
1.
2.
1.
2.
3.
Note: When zones are bypassed, security Is Do not
instruct temporary users on use of the bypass feature.
To Bypass A Zone
The system must be disarmed.
Press the BYPASS key then enter the number of the zone (l-6) to be
bypassed.
The corresponding ZONE indicators (l-6) will blink to indicate zones that have
been bypassed. The blinking will cease 30 seconds after the system is
armed and
the exit delay expires.
Repeat steps 2 and 3 to bypass other zones.
To Cancel A Zone Bypass
The system must be disarmed.
Press the BYPASS key followed by the number of the zone (l-6) to be
restored to service.
The ZONE indicator of the previously bypassed zone will stop blinking.
To Cancel All Zone Bypasses
Press the BYPASS key followed by key 9
All ZONE indicators will stop flashing. The zones are returned to operation.
To Bypass All Faulted Zones Simultaneously
available in U.L. Listed Systems).
The system must be disarmed.
Press the BYPASS key then press the 0 key.
All faulted zones will simultaneously be bypassed. The corresponding ZONE
indicators (l-6) will blink to indicate zones that have been bypassed. The
blinking will cease 30 seconds after the system is armed.
9