Additional inf orma tion – Sony MHC-EC719IP User Manual
Page 25
25
GB
Additional Inf
MHC-EC919iP/EC719iP.4-467-786-22(1)
General
The system does not turn on.
Is the power cord plugged in?
The system has entered standby mode
unexpectedly.
This is not a malfunction. The system
enters standby mode automatically
in about 30 minutes when there is
no operation or audio signal output.
See “To turn off the automatic
The clock setting or the Play Timer
operation has been cancelled
unexpectedly.
If about a minute elapses with
no operation, the clock setting
or Play Timer setting is cancelled
automatically. Perform the operation
again from the beginning.
There is no sound.
Are the + and speaker cords short-
circuited?
Are you using only the supplied
speakers?
Is anything blocking the ventilation
holes of the system?
The specified station may have
temporarily stopped broadcast.
Sound comes from one channel, or the
left and right volumes are unbalanced.
Place the speakers as symmetrically
as possible.
Connect only the supplied speakers.
Severe hum or noise.
Move the system away from sources
of noise.
Connect the system to a different
wall outlet.
Install a noise filter (available
separately) to the power cord.
The remote control does not function.
Remove any obstacles between
the remote control and the remote
control sensor on the unit, and
position the unit away from
fluorescent lights.
Point the remote control at the
system’s sensor.
Move the remote control closer to
the system.
Except
, no buttons on the unit
work, and “LOCK ON” appears on the
display.
The child lock function has been
enabled. To disable the child lock,
hold down
on the unit until “LOCK
OFF” appears on the display.
A disc cannot be ejected and “LOCKED”
appears on the display.
Contact your Sony dealer or local
authorized Sony service facility.
CD/MP3 disc
The sound skips, or the disc will not
play.
Wipe the disc clean, and replace it.
Move the system to a location away
from vibration (for example, on top
of a stable stand).
Move the speakers away from the
system, or place them on separate
stands. At high volume, speaker
vibration may cause the sound to
skip.
Play does not start from the first track.
Set the play mode to normal play
mode.
Starting playback takes more time than
usual.
The following discs can increase the
time it takes to start playback;
a disc recorded with a complicated
tree structure.
a disc recorded in multisession
mode.
a disc that has not been finalized
(a disc to which data can be
added).
a disc that has many folders.
iPod/iPhone
There is no sound.
Make sure the iPod/iPhone is
connected securely.
Make sure the iPod/iPhone is
playing music.
Make sure the iPod/iPhone is
updated with the latest software. If
not, update the iPod/iPhone before
using with the system.
Adjust the volume.