beautypg.com

Projecting, Press the input key to select the input source, Turn on equipment connected to the projector – Sony VPL-VW10HT User Manual

Page 18

background image

18

(GB)

Projecting

4

Press the INPUT key to select the input source.

INPUT-A:

Selects video signal input from the INPUT
A connector, such as component
equipment.

INPUT-B:

Selects video signal input from the INPUT
B connector, such as component
equipment.

VIDEO:

Selects video signal input from the VIDEO
(VIDEO IN) jack.

S-VIDEO:

Selects video signal input from the S
VIDEO (VIDEO IN) jack.

5

Press the PATTERN key on the control panel to
display the test pattern, and turn the focus ring to
adjust the focus.
Press the PATTERN key again to clear the test
pattern.

6

Turn the zoom ring to adjust the size of the
picture.

Note

Looking into the lens when projecting may cause
injury to your eyes.

To

Press

Cut off the picture

the MUTING PIC key on the remote
commander. To restore the picture,
press the MUTING PIC key again.

1

After all equipment is completely connected, plug
the AC power cord into the wall outlet.

The ON/STANDBY indicator lights in red and the
projector goes into the standby mode.

2

Press the

I

/

1 key on the control panel or

the

I

key on the Remote Commander.

The ON/STANDBY indicator lights in green.

3

Turn on equipment connected to the projector.

Projecting

LAMP/

COVER

TEMP/

FAN

POWER
SAVING

ON/

STANDBY

MENU

LIGHT

VIDEO MEMORY

ENTER

PATTERN

RESET

INPUT

MUTING

INPUT SELECT

VIDEO MEMORY

PIC

VIDEO

S VIDEO

A

1

2

3

4

OFF

MENU

ENTER

RESET

5

6

B

2
4

1

5,6

5

2

4