Acer 5710 - Manual (Page 82)

78 Chapter 4
Error Message List
No beep Error Messages FRU/Action in Sequence
No beep, power-on indicator turns off and LCD is
blank. Power source (battery pack and power adapter). See “Power
System Check” on page 71..
Ensure every connector is connected tightly and correctly.
Reconnect the DIMM.
LED board.
System board.
No beep, power-on indicator turns on and LCD is
blank. Power source (battery pack and power adapter). See “Power
System Check” on page 71..
Reconnect the LCD connector
Hard disk drive
LCD inverter ID
LCD cable
LCD Inverter
LCD
System board
No beep, power-on indicator turns on and LCD is
blank. But you can see POST on an external
CRT. Reconnect the LCD connectors.
LCD inverter ID
LCD cable
LCD inverter
LCD
System board
No beep, power-on indicator turns on and a
blinking cursor shown on LCD during POST. Ensure every connector is connected tightly and correctly.
System board
No beep during POST but system runs correctly. Speaker
System board