Sony ST-SE200 - Manual (Page 6)

6 GB
Receiving Broadcasts
This section describes various ways to tune in AM and
FM broadcasts. Before tuning, be sure to connect the
supplied AM and FM aerials.
1
Turn on the amplifier and select the TUNER
mode.
2
Press POWER to turn on the tuner.
3
Press BAND to select FM or AM.
4 Press TUNING + or –.
Press + for a higher frequency
Press – for a lower frequency
For automatic tuning
Hold down TUNING + or – for about 1 second and
release it when the frequency numbers start changing.
When the tuner locates a station, it stops automatically
and “TUNED” appears in the display.
To stop automatic tuning before a station is located
Press TUNING + or –.
For manual tuning
Press TUNING + or – repeatedly to select the frequency
you desire. "TUNED" appears when a station is tuned
in.
5
Repeat step 4 until the desired station is received.
When an FM stereo program is noisy
When the tuner receives an FM stereo program, the
STEREO indicator lights in the display window. If the
stereo program is noisy, press STEREO/MONO to
change the tuning mode over to MONO. This eliminates
the stereo effect, but the noise will be greatly reduced.
When you tune in AM stations
Adjust the direction of the AM loop aerial for optimum
reception.
Presetting Radio Stations
You can store up to 20 FM and 10 AM stations.
1
Tune in the FM or AM station you wish to store.
2
Press MEMORY.
“MEMORY” and the last memorized number
appear in the display.
3
Use the number buttons (1-9, 0/10 and >10) to
select a preset number.
To select press
5 5
10 0/10
15 >10 / 1 / 5
20 >10 / 2 / 0/10
The tuner stores the station at the preset number
you specified.
4
Repeat steps 1 through 3 to store other stations.
If “MEMORY” goes out from the display before you
select the preset number
Press MEMORY again.
Tuner Operations
TUNING (+/–) POWER
BAND STEREO/MONO
Number buttons
MEMORY