AT&T 9452 - Manual (Page 27)

Remote Access Commands
Function: Command:
Play messages in Press
#, then the appropriate mailbox
a mailbox number (
1, 2, or 3). The system plays
new messages. If there are no new
messages, the system plays old messages.
Repeat a message Press
# 4 while message is playing to
return to message beginning; each press
goesback another message.
Skip a message Press
# 6 while message is playing;
each press advances another message.
Stop Press
# 5.
Save messages Hang up.
Delete message Press
# 9 while message is playing.
Review announcement Press
# 7; system plays announcement,
then beeps.
Record announcement Press
* 7; after beep, record
announcement, press
# 5 to stop.
System plays back announcement.
Record memo Press
* 8; then mailbox number where
you want memo recorded; speak after
beep; press
# 5 to exit.
End remote access call Press
* 0.
Turn system off Press
# 0; the system announces,
“The machine is off.” Press
# 0 again
to turn the system back on.
Turn system on When system is off, it answers after 10
rings and announces, “Please enter your
security code.”
Press
#, then enter your
remote access code.
NOTE: The remote access call will automatically end after 20 seconds
without a key press (other than when recording or playing messages or
announcements).
ANSWERING SYSTEM OPERATION
25
9452_book_1ATT 10/5/00 3:18 PM Page 25