AT&T 9452 - Manual (Page 10)

4 Mount the base on the wall.
4 Plug the power cord into the outlet.
5 Charge the handset battery.
Place the handset in the base. Charge the battery for at least 16 hours
the first time. After the first charge, the battery is typically fully
charged overnight.
6 Check for dial tone.
After the batteries are charged, pick up the handset, press
L, and
listen for a dial tone. Then press
l. If you don’t hear a dial tone, see
“IN CASE OF DIFFICULTY.”
INSTALLATION
8
a) Align holes on
base with
mounting studs
on wall jack.
b) Place power cord
as shown, guiding
it through tabs on
base. c) Pull base down on
mounting studs
until it locks into
place.
9452_book_1ATT 10/5/00 3:17 PM Page 8