ATN NVM14 User Manual

Page 26

CAUTION

It is recommended that the eyecup be replaced with the eye-

guard during weapon-mounted use.

NOTE

The ATN NVM-14 is not a weapon sight, however, it can be

used in conjunction with a collimated dot sight or laser aiming

device.

C. MOUNTING THE ATN NVM-14 TO THE WEApON

To mount the ATN NVM-14 perform the following:
1. Loosen the clamping knob on the weapon mount. Position the

monocular mount on the weapon’s mounting rail, adjust the

fore/aft position of the monocular as necessary by loosening

the clamping knob and repositioning the weapon mount on the

rail. Tighten by turning the clamping knob).

2. Align the monocular and the weapon mount. Slide the monoc-

ular rearwards until the alignment boss aligns with the align-

ment groove on the weapon mount. Push until the monocular

locks into the weapon mount (see figure 3-1).

Figure 3-3

Attaching ATN NVM-14 to Weapon Mount