Sony SU-WL700 - Manual (Page 7)

7
(GB)
3
Install the Base Bracket on the
wall
When using an electric screwdriver, set the torque setting to
approximately 1.5 N·m {15 kgf·cm}.
4
Prepare for the installation of
the Display
1 Attach the Joint Bracket C to the Base
Bracket AB securely.
Use four screws H (+BVST4 × 8).
2
Secure the assembled Base Bracket to the
wall.
Use four or more screws of 8 mm ( 11 / 32 inches)
diameter or equivalent (not supplied).
~
• Be sure to align the assembled Base Bracket so that it is
level.
1 Make sure that the Table-Top Stand is removed
(if necessary).
If the Display has the Table-Top Stand attached, it
should be removed before carrying out the procedure
below. Refer to the operating instructions supplied with
your Display.
~
• When removing the Table-Top Stand from the Display, lay
the display face down on a stable work surface that is larger
than the Display.
• To prevent damaging the surface of the LCD display, make
sure to place a soft cloth on the work surface.
• When lifting or moving the Display, keep a soft cloth
underneath to prevent damage.
• The number and position of the screws on the rear of the
Display differs, depending on the model of Display; be sure
to read the operating instructions of your Display.
CAUTION
• If pressure or shock is applied to the surface of the Display,
the LCD display may break or become damaged.
• Lay the display face down on a stable and level surface with
the Table-Top Stand hanging over the edge of the surface.
Having the display face and the base of the Table-Top Stand
on the same level surface will create an unstable working
condition and can damage the Display.
• When detaching the Table-Top Stand from the Display,
hold the Table-Top Stand securely with both hands.
2
Place the Spacers (for KDL-40ZX1/KLV-
40ZX1M only).
1 Remove the four screws from the rear of the
Display.
2 Place the Spacers (supplied with your Display) on
the screw holes of the previous procedure.
Refer to the operating instructions supplied with your
Display.
3
Attach the Mounting Bracket DE to the rear
of the Display temporarily.
Temporarily tighten the top of the Mounting Bracket
DE
using two screws I (+PSW M6 × 16).
4
Attach the Lock Bracket F to the bottom of
the Mounting Bracket DE.
1 Temporarily move the bottom of the Mounting
Bracket DE outwards.
~
• If the bottom of the Mounting Bracket does not move,
loosen the screws (return to step 3).
2 Insert the pins of the Mounting Bracket DE
through the holes of the Lock Bracket F. Return
the Mounting Bracket DE to their original
position to attach the Lock Bracket F.
5
Confirm the Sony optional Speaker System
connection (for KDL-40ZX1/KLV-40ZX1M only).
When connecting the Speaker System to the
Display, connections should be made before the
following wall mounting procedure. Refer to the
instruction manual supplied with your Speaker
System and Display beforehand.
6
Secure the Mounting Bracket DE to the rear
of the Display.
When using an electric screwdriver, set the torque
setting to approximately 2 N·m {20 kgf·cm}.
1 Tighten the bottom of the Mounting Bracket DE
using two screws I (+PSW M6 × 16).
2 Be sure that all screws are securely tightened with
equal torque to the rear of the Display.
(Continued)