Sony SU-WL700 - Manual (Page 6)

6
(GB)
1
Check the parts
2
Decide on the installation location
Installation
1
Verify that all parts are included.
Prepare four or more screws of 8 mm ( 11 / 32 inches)
diameter or equivalent (not supplied). Select screws
suitable for the material of the wall.
A
×1
Base Bracket (top) B
×1
Base Bracket (bottom)
C
×2
Joint Bracket D
×1
Mounting Bracket R
E
×1
Mounting Bracket L
×1
F Lock Bracket
G
×1
Hexagon wrench H
×4
Screw (+BVST4 × 8)
I Screw (+PSW M6 Ч 16)
Ч4
J
×1
Screw (+PSW M5 × 8)
K Assembly sheet
×1
L
×1
Paper template
1
Decide on the installation location.
Refer to the installation dimensions table on page i
(end of this manual).
Allow for suitable clearance between the Display and
the ceiling and protruding parts of the wall as shown
below.
Unit: mm (inches)
Never install the Display as shown below:
~
• If you intend to route the cables in the wall, make a hole in
the wall to insert the cables before beginning the
installation.
To prevent pinching the cables, prepare a hole in the wall
somewhere outside the perimeter of the Base Bracket.
2
Decide the positions of the screws for
installing the Base Bracket AB.
Refer to the specifications on page 5.
WARNING
The wall that the Display will be mounted on
should be able to support a weight of at least four
times that of the Display (Refer to your Display’s
operating instructions for its weight.).
Determine the strength of the wall the Display will
be mounted on. Reinforce the wall sufficiently, if
necessary.
100
(4)
100
(4)
300
(11
7
/ 8
)
10
0
(4
)
Air circulation is
blocked.
Wall