Karcher KM 120-150 R Bp 2SB - Manual (Page 26)

- 7
Î Switch off the charger and remove the
plug from the socket.
Î If the machine does not have a built-in
charger: Pull the battery cable from the
charger cable and connect it to the ma-
chine.
Batteries and chargers are available in spe-
cialised stores.
Pay attention to the following if you are us-
ing maintenance-free batteries in KM 120/
150 R Bp:
– It is necessary to conform to the maxi-
mum battery dimensions.
– While charging maintenance-free bat-
teries, it is necessary to tilt the seat up-
ward.
– While charging maintenance-free bat-
teries, follow the specifications of the
battery manufacturer.
ṇ Warning
Regularly check the fluid level in acid-filled
batteries.
Î
Unscrew all cell caps.
Î Where fluid level is too low, top up cells
to the mark provided with distilled wa-
ter.
Î Charge battery.
Î Screw in cell caps.
Î Disconnect battery.
Î Remove the battery from the battery
holder.
Î Dispose of the used batteries according
to the local provisions.
ṇ
Warning
Do not use a forklift truck to unload the ma-
chine as this may damage it.
Note
Press the emergency-stop button to imme-
diately deactivate all functions and turn the
key switch to the "0" position.
To unload the machine, proceed as follows:
Î
Cut plastic packing belt and remove foil.
Î Remove the elastic tape fasteners at
the stop points.
Î Four indicated floor boards of the pallet
are fastened with screws. Unscrew
these boards.
Î Place the boards on the edge of the pal-
let. Place the boards in such a way that
they lie in front of the four wheels of the
machine. Fasten the boards with
screws.
Figure 7
Î Slide the four support beams included
in the packaging under the ramp.
Î Remove the wooden blocks used for ar-
resting the wheels and slide them under
the ramp.
Î Loosen immobilizing brake (see "move
sweep machine").
Î Slide the machine over the prepared
ramp from the pallet.
Î Connect battery (see section on Care
and maintenance)
Î Release emergency-stop button by
turning.
Î Set main switch to "1".
Î Press the drive direction switch and
slowly move the machine down from
the ramp.
Î Set main switch back to "0".
ƽ Danger
Risk of injury! Before releasing the immobi-
lizing brake, the machine must be secured
to prevent it rolling away. After releasing
the immobilizing brake, the machine roles
without brakes.
Figure 8
Î Remove the brake level from the wheel
and put it in its position.
The immobilizing brake is thus deactivated;
the machine can now be moved.
ṇ
Warning
Danger of damage to the controls! Never
move the machine faster than 8 km/h.
Î Park the sweeper on an even surface.
Î Remove the key.
Î Check charging status of battery. *
Î Check side brush. *
Î Check roller brush. *
Î Empty waste container.
* For description, see section on Care and
maintenance.
Note
Press emergency-stop switch to immedi-
ately switch off all functions of the machine.
Î Pull seat adjustment lever outwards.
Î Slide seat, release lever and lock in
place.
Î Check that the seat is properly locked in
position by attempting to move it back-
wards and forwards.
ƽ
Danger
Danger of accident. The immobilizing brake
must always be checked first on an even
surface before starting the machine.
Î
Take the seating position.
Î Release emergency-stop button by
turning.
Î Set main switch to "1".
Î Select pedal for direction of travel.
Î Gently depress drive pedal.
Î The brake must get released and you
must be able to hear it (the control lamp
for immobilizing brake on the console
switches off). The machine must roll
slightly on a plane surface. When the
pedal is released, the brake falls in in an
audible manner. Switch off the ma-
chine and call the aftersales service if
the above-mentioned events do not oc-
cur.
After charging
Recommended batteries, chargers
Order number
Battery incl. charg-
er 240 Ah 2.641-044
Battery incl. charg-
er 400 Ah 2.640-996
Maximum battery dimensions
Length Width Height
827 mm 324 mm 462 mm
Check fluid level in the battery and ad-
just if required
Remove the battery
Unloading
(1) Machine without built-in battery
(2) Machine with built-in battery
Move the sweep machine
Start up
General notes
Inspection and maintenance work
Operation
Adjusting driver's seat
Check immobilizing brake
26 EN